This unique Wheel system is designed specifically for snow bikes (fits all snow bike brands), it will make moving your snow bike completely hassle free. The front wheel securely attaches to the ski and is tightened down with a ratchet strap. The back wheel simply sits down into the lugs of the track and self aligns. The system can be installed in a few seconds allowing you to easily push your bike around on any surface without it tipping over. You can also use them to push your snow bike up a ramp into a truck bed and/or to ride your snow bike in and out of the trailer or down a gravel roads that has no snow on it.

This bag is one of the most commonly used on the Mtn. Horse snow bike system. It can be mounted in two different locations. It can be mounted to the the top of the tubular sub frame. It can also mounted on the back of the tunnel behind the gas can if you have one of those. The top of the tunnel is pre drilled for the bag in this location and will fasten down with supplied hardware.

This bag is most commonly used on Motocross bikes that do not have a headlight. To mount it on the bike you remove the front number plate and replace it with the bag. It simply straps on around the fork tubes and the handlebar clamps. It works perfect for your lunch and a dry set of gloves. The bag is easy to take on and off, so that you can take it into the house for restocking at the end of your ride.

This bag is more like a trunk in your car, it is very large a will work well for carrying everything you can think of. It mounts to a track system that bolts to the the tunnel in factory pre drilled hole located on the top of the tunnel. This is the same mounting position and mounting track that is used for the 3.3 gal. gas can. Once the track is mounted you can simply slide the unit on and off the track with no other straps needed to hold it.

With this system you can use the bag or the gas can on the same track or if you choose to have both then the bag can be mounted behind the gas can with a second set of mounting track. The bag has rigid bottom and side, with a soft zip down top so it will form to it's contents. It also has elastic bands on top so that you can hold other things on the outside of it.

This can mounts to a track system that bolts to the tunnel in factory pre drilled hole located on the top of the tunnel. This is the same mounting position and mounting track that is used for the tunnel trunk/bag. Once the track is mounted you can simply slide the unit on and off the track with no other straps needed to hold it. With this system you can use the gas can or bag on the same track or if you choose to have both then the bag can be mounted behind the gas can with a second set of mounting track.

This can and bag mount to a track system that bolts to the tunnel in factory pre drilled hole located on the top of the tunnel. Once the track is mounted you can simply slide the units on and off the track with no other straps needed to hold them.

This jack stand is a must for the Mtn. Horse snow bike because it is mandatory to lift and spin the track and drive system with the engine running to properly lube the chains and check adjustment of both chain and suspension tuning. It is designed to simply lift the back of the tunnel with one push on the handle. It has a lifting fork that fits the width of the tunnel and fits the aluminum bumper tube. It then has a lifting cam that lifts the back of the tunnel and then cams over center to stay up and also has a safety pin to lock it in the up position.

This 5 foot long brake line allows you to connect your stock hand brake lever and master cylinder to the snow bike brake caliper.